• <li id="4u0ko"></li>
    <nav id="4u0ko"></nav>
  • <legend id="4u0ko"></legend>
  • <input id="4u0ko"><noscript id="4u0ko"></noscript></input>
    自上料攪拌車廠家

    全國咨詢熱線

    400-879-1999

    點擊撥打服務熱線:400-879-1999
    你所在位置: 首頁 >> 自動上料攪拌車資訊 > 公司新聞 >

    公司新聞

    自動攪拌車輪胎多久需要更換一次?

    作者:http://www.kenguscpas.com 時間:2021-01-20

    1.胎面深度
    1. Tread depth
    胎面花紋的厚度應大于1.6毫米。如果在低摩擦的潮濕路面上行駛,請確保胎面花紋的厚度是上述值的兩倍。盡管您可以從專家那里學習并購買量規來測量胎面花紋的厚度,但是老司機經常使用流行的方法來估算胎面花紋的厚度。費用為$ 1。向上插入胎面槽,因為從邊緣到頂部的距離為1-2 mm。此時,您可以看到胎面花紋的總厚度不足。
    The thickness of tread pattern shall be greater than 1.6 mm. If driving on wet roads with low friction, make sure that the tread thickness is twice the above value. Although you can learn from experts and buy gauges to measure tread thickness, old drivers often use popular methods to estimate tread thickness. The cost is $1. Insert the tread groove upward because the distance from the edge to the top is 1-2 mm. At this time, you can see that the total thickness of tread pattern is insufficient.
    2.花紋磨損指示線
    2. Indication line of pattern wear
    與過去的舊產品相比,新的輪胎設計更加人性化:胎面花紋磨損指示器。如果輪胎是新輪胎或磨損程度很低,則幾乎看不到這些指示,但是當磨損達到一定程度時,您會發現這些線條隱藏在胎面花紋溝中。胎面花紋磨損指示器線是扁平橡膠條,其垂直嵌入胎面的垂直胎面槽中。如果檢查輪胎并偶爾發現一兩個指示線,則胎面花紋會明顯變薄。在這種情況下,在濕滑的路面上行駛時要小心。如果您可以清晰地看到輪胎上幾乎所有的指示線,則意味著您需要盡快更換輪胎。
    小型攪拌車
    Compared with the old products, the new tire design is more humanized: tread wear indicator. If the tire is new or the wear level is very low, these indications can hardly be seen, but when the wear reaches a certain level, you will find that these lines are hidden in the tread groove. The tread pattern wear indicator line is a flat rubber strip which is vertically embedded in the vertical tread groove of the tread. If the tire is inspected and one or two indicator lines are occasionally found, the tread pattern will become significantly thinner. In this case, be careful when driving on slippery roads. If you can clearly see almost all the indicator lines on the tire, it means that you need to change the tire as soon as possible.
    3.輪胎胎側裂紋
    3. Tire sidewall crack
    并非所有輪胎問題都集中在胎面上,輪胎胎側也存在一些問題。檢查輪胎的側壁是否有明顯的裂紋或割傷。這些小凹槽表明輪胎將來可能會漏氣,更糟糕的是,輪胎可能會爆裂。這些輪胎的故障是我們要避免的事情。因此,如果輪胎側壁上的裂紋看起來更嚴重,則將車輛開到修理廠并盡快更換輪胎。
    Not all tire problems are concentrated on the tread, and there are also some problems on the sidewall. Check the sidewall of the tire for obvious cracks or cuts. These small grooves indicate that the tire may leak in the future, and worse still, the tire may burst. The trouble with these tires is something we should avoid. Therefore, if the cracks on the sidewall of the tyre appear to be more serious, drive the vehicle to the repair shop and replace the tyre as soon as possible.
    4.輪胎脹大和脹大
    4. Tire inflation and inflation
    由于缺乏強度,輪胎的外表面可能會比普通輪胎的表面升高并且起泡更多。輪胎也面臨類似情況。如果您未能及時運送到修理廠并發現輪胎故障,則胎面強度不足的零件可能會突然高速破裂。輪胎破裂甚至會對駕駛員和乘客造成嚴重傷害。
    Due to the lack of strength, the outer surface of a tire may rise and blister more than that of a normal tire. Tires face a similar situation. If you fail to deliver the tire to the repair shop in time and find the tire failure, the parts with insufficient tread strength may suddenly crack at high speed. Tire rupture can even cause serious injury to the driver and passengers.
    駕駛車輛時不可避免地會發生一定程度的抖動,尤其是在惡劣的道路條件下。有了一定的駕駛經驗,您可以感覺到抖動在合理范圍內,并且抖動表明車輛出現故障。
    It is inevitable that a certain degree of shaking will occur when driving, especially in bad road conditions. With some driving experience, you can feel the jitter within a reasonable range, and the jitter indicates that the vehicle is faulty.
    上一篇:小型混凝土攪拌車制動系統操作方式
    下一篇:攪拌配件的損傷修復哪些地方?

    TAG:自上料攪拌車,自動上料攪拌車, 全自動攪拌車,小型攪拌車

    截屏,微信識別二維碼

    微信號:1234567

    點擊微信號復制,添加好友

     打開微信

    毒龙钻服务